control-StringPoint

This point is a basic read-only control point, with default slots: Facets, Out, and ProxyExt.

This point is available in the Points folder of the control palette and usually resides in a device’s Points folder.

Figure 1. String Point Property Sheet


You can access these properties in the Property Sheet by expanding Station > Config > Drivers > Points and double-click on StringPoint.

PropertyValueDescription
FacetsConfig Facets window
Defines a range of enumerated states (enum values).
Proxy Ext, OutvalueReports both numeric and alpha values, facets and data status such as fault, overridden, alarm, and so on. If no status flag is set then status is considered normal and reports {ok}