You can add a relation between two components within a
Wire Sheet simply by dragging a connector from lower end of one component
to the lower end of another.
- In a Wire Sheet view, click the Workbench Wire Sheet menu and click Show Relations.
- On the desired “Relate To” component, click
the component’s footer and drag to the component footer for
the desired “Relate From” component.
A Relation dialog appears.
- From the pull-down list, click on the desired Relation Id and click OK.
Note: This pull-down list is populated from the Relation Definitions
defined in the selected Tag Dictionary.
In the Wire Sheet view, the relation is shown as a dashed
line between the two components. Both of the components have the Relation
Id for the slot displayed name.
