Setting up an alternate default prototype

You may configure an alternate default user prototype using the baja-UserPrototype component.

You are working in Workbench connected to a Supervisor or remote station.
  1. Open the baja or ldap palette.
  2. Drag a UserPrototype component from either the baja or ldap palettes to the User Prototypes folder under the UserService.
  3. Give the UserPrototype a name that matches the desired attrPrototype value.
    attrPrototype is a property on the Kerberos Config AX Property Sheet.
    The component displays a list of user properties including Full Name, Enabled, Expiration, etc. Each property contains two sub-properties: Overridable and value.
  4. Configure each user property and click Save.
    You now have an alternate default user prototype.
  5. To replace the standard default user prototype with the one you just created, navigate to the User Prototypes folder under the UserService and set the Alternate Default Prototype property to the new default user prototype.