This procedure describes how to set up the NrioService in the ACE App to use the ACE Nrio Points components to control actual
IO-R modules.
Prerequisites:
- You are connected to the station running on an Edge device.
- There is an existing AceEdgeNetwork with ACE App installed and running.
- The ACE driver is configured to use AceNrio.
- The aceEdge palette is open.
Perform the following steps:
- Open the ACE App wire sheet.
- Open the ACE Catalog sidebar.
- From the
Ace Nrio subfolder in the sidebar, drag the NrioService onto the App wire sheet.
NOTE: The NrioService is required in the ACE app in order to use NRIO devices.
- From the Ace Nrio subfolder in the sidebar, drop an NrioXXDevice onto the ACE App wiresheet, where NrioXXDevice is either
Nrio16Device or Nrio34Device.
- Right-click the NrioDevice and click .
- In the Match window, click Discover, click to select one of the discovered UUIDs and click Match.
The NrioDevice component’s status should be OK
The ACE App is configured for Nrio. You can add points next.