kitControl-StatusEnumToStatusNumeric

This component converts a StatusEnum Out value to a StatusNumeric In value.

StatusEnumToStatusNumeric is available in the Conversion folder of the kitControl palette.

Property	Value	Description
Facets	Config Facets window (defaults to null for units and one decimal place of precision)	Selects units and configures how the value displays: units defines the measure from acceleration to the volumetric flow. precision defines the number of decimal places. This configuration applies to the In property value.
Out	read-only number	Displays the converted target status numeric value.
In	number and null definition (defaults to 0)	Displays the source status enum value. When null is checked, the value displayed defaults to the incoming value from the device. If you remove the check mark you can configure theIn value.

Property

Value

Description

Facets

Config Facets window (defaults to null for units and one decimal place of precision)

Selects units and configures how the value displays:

units defines the measure from acceleration to the volumetric flow.

precision defines the number of decimal places.

This configuration applies to the In property value.

Out

read-only number

Displays the converted target status numeric value.

number and null definition (defaults to 0)

Displays the source status enum value.

When null is checked, the value displayed defaults to the incoming value from the device. If you remove the check mark you can configure theIn value.