Updating connections using a provisioning station’s DHCP Server

This procedure creates a one-time provisioning job to update the JACE-9000-to-station connections using information pulled from the DHCP server running on the JACE-9000 provisioning station (the Supervisor). It updates the IP address and port information for Fox and Platform connections based on the discovery results. It is intended to be used in installations where a JACE-9000 is acting as a Supervisor for a group of Edge devices connected through the secondary network port.

The BatchJobService is available under the Services folder and the ProvisioningNwExt component is available under your NiagaraNetwork. The Niagara Network Job Builder (for a one-time job) or the Niagara Network Prototype View (for a prototype job) is open.
Note: Only Edge devices respond to this request in a NiagaraNetwork. Controller devices do not respond to these requests.
  1. In the Niagara Network Job Builder window, top pane, Provisioning steps to run, click add ().
    The New Job Step window opens.
  2. Click the Update Connections Using Provisioning Station’s DHCP Server step and click OK.
  3. In the bottom pane, Stations to include in the job, click add ().
    The Add Device window opens.
  4. Select the stations and click OK.
    The Niagara Network Job Builder view reports your choices.
  5. To initiate the provisioning job, review your choices and click Run Now at the bottom of the view.
    The view changes to the Niagara Network Job View, where steps and results appear as they are executed.