Setting the time

This procedure creates a provisioning job to set the time on each remote device in the job.

The BatchJobService is available under Services. The ProvisioningNwExt component is available under the NiagaraNetwork. The Niagara Network Job Builder (one-time) or Niagara Network Prototype View (reoccurring job) is open.
  1. In the top pane, Provisioning steps to run, click add ().
    The New Job Step window opens.
  2. Select the Set Time step and click OK.
    The system opens the Set Time window.

  3. Select the bullet and configure the time as needed, and click OK.
  4. In the bottom pane, Stations to include in the job, click add ().
    The Add Device window opens.
  5. Select the stations and click OK.
  6. To initiate the provisioning job, review your choices and click Run Now at the bottom of the view.
    The view changes to the Niagara Network Job View, where steps and results appear as they are executed.