Setting the reciprocal connection

This procedure creates a provisioning job to set up the reciprocal connection to enable the station-to-Supervisor Fox connection under the NiagaraNetwork of each remote station.

The BatchJobService is available under the Services node and ProvisioningNwExt component is available under your NiagaraNetwork in the Nav tree. The Niagara Network Job Builder (for a one-time job) or the Niagara Network Prototype View (for a prototype job) is open.
  1. In the top pane, Provisioning steps to run, click add ().
    The New Job Step window opens.
  2. Select the Set Reciprocal Connection step and click OK.
    The system opens the Setup Reciprocal Niagara Network Connection window, which prompts for the Supervisor connection information.

  3. Enter the credentials to use for the station-to-Supervisor connection, and click OK.
  4. In the bottom pane, Stations to include in the job, click add ().
    The Add Device window opens.
  5. Click to select the stations and click OK.
    The Niagara Network Job Builder view reports your choices.
  6. To initiate the provisioning job, review your choices and click Run Now at the bottom of the view.
    The view changes to the Niagara Network Job View, where steps and results appear as they are executed.