Setting a property

This procedure creates a provisioning job to set a property value of a component on each remote station in the job.

The BatchJobService is available under Services. The ProvisioningNwExt component is available under the NiagaraNetwork. The Niagara Network Job Builder or Niagara Network Prototype View is open.
  1. In the top pane, Provisioning steps to run, click add ().
    The New Job Step window opens.
  2. Click the Set Property step and click OK.
    The Set Property window opens.

  3. Enter the slot path (Target ORD) for the target component, the Property Name to change, the Property Type information, the Property Value and click OK.
  4. In the bottom pane, Stations to include in the job, click add ().
    The Add Device window opens.
  5. Select the stations for which to change the property value and click OK.
  6. To initiate the provisioning job, review your choices and click Run Now at the bottom of the view.
    The view changes to the Niagara Network Job View, where steps and results appear as they are executed.