Creating a one-time job

This procedure demonstrates the general procedure used to create one-time provisioning jobs.

The Supervisor is licensed for provisioningNiagara, the BatchJobService is available under Services folder and ProvisioningNwExt component is available under your NiagaraNetwork.
  1. Under the Supervisor station’s NiagaraNetwork, double-click ProvisioningNwExt.
    The Niagara Network Job Builder view opens.

  2. In the top pane, Provisioning steps to run, click add ().
    The New Job Step window opens.

  3. Select the job step, for example, Enable Bootstrap Mode and click OK.
  4. To select the stations to provision, do one of the following:
    • Drag the stations from the NiagaraNetwork in the Nav tree one by one into the bottom pane, Stations to include in the job.
    • Click add () or right-click in the Stations to include in the job and click Add.
    If you clicked to add stations, the Add Device window opens.

  5. Choose the station(s) or, to select them all, click Check All and click OK.
    The system adds the job step and stations to the job builder.

  6. Review your choices and click Run Now at the bottom of the job builder.
    The view changes to the Niagara Network Job View, where steps and results appear as the system executes them.

    Note: Running this step by itself makes no persistent change on the target stations.