| Path |
Displays the ord path of point. |
| Name |
Displays the name of point. |
| Type |
Indicates the type of point. |
| Out |
Reports the current out value, including any point facets. This defaults to the single (configured) property value along with
status for the proxy point.
|
| Enabled |
Reports if the proxy point is currently enabled for communication. |
| Tuning Policy Name |
Displays the name of the tuning policy |
| Absolute Address |
Displays the actual address that uses when polling for this discrete data point from the actual Modbus device. |
| Fault Cause |
Indicates the condition at the last check. |
| Poll Frequency |
Displays the poll services that is used in the device. |
| Data Address |
Displays the address of the polled data item |
| Reg Type |
Displays the register type. |
| Data Type |
Displays the location of data. |
| Status Type |
Displays the location of points. |
| Bit Number |
Displays the bit number. |
| Beginning Bit |
Displays the bit in the register. |
| Number of Bits |
Displays the number of bits used for point. |
| Data Source |
Displays the data source. |
| Number Registers |
Displays the number of consecutive holding registers to read. |
| Device Facets |
Represents the facets learned from the point. |
| Facets |
Displays the facet value. |
| Conversion |
Displays the units to use when converting values from the device facets to point facets. |
| Read Value |
Displays the value read by the driver. |
| Write Value |
Displays the value to be written. |