Update Network Settings

Use system shell menu option ‘2’ to access most of the same IP networking options available in the Commissioning Wizard step “TCP/IP configuration”. When selected, you are prompted for each setting sequentially, starting with hostname (shown below).

Update Network Settings example in the System Shell

Network Configuration Utility
Enter new value, '.' to clear the field or '<cr>' to keep existing value.

Hostname <localhost> : J8_East
Domain <> : myDomain.net
Primary DNS Server <> : 8.8.8.8
Secondary DNS Server <> : 8.8.4.4
Route <192.168.1.1> :
Primary IPv6 DNS Server <> :
Secondary IPv6 DNS Server <> :
IPv6 Route <> :

NET1 Ethernet interface (en0)  
 IP address (clear to use DHCP) <> : 192.168.1.36  
 Subnet mask <255.255.255.0> :  
 Enable IPv6 addressing on this adapter? (Y/n) :  
 IPv6 address (clear to use stateless autoconfiguration) <> :

Enable NET2 (en1) interface? (y/N) : Y
NET2 Ethernet interface  
 IP address (clear to use DHCP) <> : 172.15.16.36  
 Subnet mask <255.255.255.0> :  
 Enable IPv6 addressing on this adapter? (Y/n) :  
 IPv6 address (only 1 adapter may use IPv6 Autoconfiguration) <> :

**** IPv6 Autoconfiguration NOT supported on NET2 interface. 
IPv6 on NET2 will be disabled.

Confirm new configuration
Hostname        : J8_East
Domain          : myDomain.net
Default Gateway : 192.168.1.1
Primary DNS     : 8.8.8.8
Secondary DNS   : 8.8.4.4
Default IPv6 Gateway :
Primary IPv6 DNS     :
Secondary IPv6 DNS   :

NET1 settings:
IP Address          : 192.168.1.36
Subnet Mask         : 255.255.255.0
IPv6 Addressing assigned via Autoconfiguration

NET2 settings:
IP Address          : 172.15.16.36
Subnet Mask         : 255.255.255.0
IPv6 Addressing assigned via Autoconfiguration

Save these settings? (Y/n) :

NOTE: After you save the network settings, they do not become active until you perform a reboot of the JACE controller. You can do this when you return to the main system shell menu, by selecting Reboot, menu option 6.

Update System Time"

If the commissioning process hasn't been completed yet, it is often important to set the current date and time (YYYYMMDDHHMM.ss). For example: 201510231536 for 23-Oct-2015 at 3:36pm UTC or 11:36 EDT.