Managing configured sources
Once you finish configuring sources you can reorder them, delete them, add new ones manually, preview and finally launch them.
Prerequisites: Your display connects successfully to all available content sources.
- To reorder the configured sources, tap and hold, then drag the handle to the right of each saved source, up or down.
- To remove a source, swipe left from the center and click the remove button.
- To add a source manually, click the ADD SOURCE MANUALLY button.The Add Source Manually window and a keyboard open.
- After manually adding the source, tap it and configure it.
- Click PREVIEW.If any sources are expanded, the application automatically saves any changes made to the source.The app displays the web content from the top saved content source. A preview bar gives you easy access back to the Network and Content Sources view.
If you have chosen more than one Source at launch point, the app superimposes an additional ribbon at the bottom of the loaded view, as above. This displays the current Source name, with a button offering you the ability to swap among sources quickly. If clicked, the view shows a list of pre-loaded sources.
- Select a source.The app loads it accordingly.
- When you are happy with the loaded content, click LAUNCH.The Launching into kiosk mode window opens.
Clicking NO closes the window.
Clicking YES puts the display into kiosk mode. To make any further changes requires a reboot.
- To continue, click YES.If you selected to view content in a browser, such as Chrome, the app starts the content within the selected browser. For convenience, the app creates a web page at launch, displaying all the sources you enabled on the launch screen.
- For speed and ease-of-use going forward, bookmark this page on first loading.Clicking on the tab for any added source launches that source’s content in a separate tab.
- To change the network connection of the launch sequence at any time, re-boot the display by pressing the power button only
once.The app displays the splash screen.
You may turn off the “TAP HERE FOR SETTINGS” hint in General Settings.
The top, right corner of the splash screen reports the version number of the app.
- Tap the screen.If you enabled the configuration password, the login page opens.
- Enter the password and tap LOGIN.The default password is: ipd_adminThe app returns to the Networks and Content Sources view.
- Adjust your requirements.The app displays, “Config Mode Active.”